I'm working on installing drilled / slotted rotors on my 2011 35i along with low dusting pads. Everything going well except for the usual stubborn bolts that finally give way with a few doses of liquid wrench.
My only problem should be pretty simple. I can't disconnect the end of the brake sensor wire that connects under the hood beneath the cross bar. Can barely see or touch the connection.
Has anyone replaced the sensor wire? Any suggestions for working with this connection?
My only problem should be pretty simple. I can't disconnect the end of the brake sensor wire that connects under the hood beneath the cross bar. Can barely see or touch the connection.
Has anyone replaced the sensor wire? Any suggestions for working with this connection?